Quick hydraulic pump question

[BigChevy17]

Would running this pump at 3400 rpm be OK?
I have the motor already off an air compressor.
It's going to be used for a tube Bender with a 3x1.5x24 cylinder.

http://www.surpluscenter.com/Hydrau...cu-in-DYNAMIC-GPF1020PA-HYD-PUMP-9-7763-D.axd

Thanks

 

[454ragtop]

No problem running the pump that fast, says it's good to 6000. Keep in mind you can use pulley sizes to control the pump RPM, no matter what the motor RPM is. Now, as to how that pump will work with your cyl., somebody smarter than me when it comes to hydraulics will have to figure that out.
HTH, Jim

 

[BigChevy17]

From what I've gathered so far that pump should be around 1 gal/min which should move my ram 1/2" per second which would be perfect for a tubing Bender.
Someone please correct me if I'm wrong.