Recommend me a micro chuck

[NoahG]

Im looking for a quality micro chuck that I can put in my M12 drill that will hold twist drill bits under 1/16". Ive seen several on the market but the quality of most looks dubious.

 

[Air21]

What holes under 1/16 are you trying to hand drill? :/

 

[Musicinabottle]

I have a couple of the sort that chuck up in a drill. No idea who makes them off the top of my head but they are American made. I used smaller than 1/16 inch bits when I cleaned a bedliner spray gun.

 

[Musicinabottle]

What holes under 1/16 are you trying to hand drill? :/

The kind that are 3/64s

 

[larry_g]

https://www.mscdirect.com/FlyerView...55162598&contentPath=/sales-catalogs/big-book

Not knowing your mount, check the above for a wide range of what is available. a few pages are there so look at them all.

lg
no neat sig line

 

[NoahG]

The kind that are 3/64s

Yup. 3/64" and 1/32" in fact.

 

[Advan]

I have an few Jacobs chucks in 5/32 - 1/4" that'll all hold a 1/32" bit. Of course these are "custom" built with machined arbours to hold in a collet or larger chuck. Jacobs does make a .250 chuck with a hex shank that'll hold down to .030.

https://www.amazon.com/dp/B004F7QJ2W/?tag=atomicindus08-20

 

[Mohawk Dave]

https://www.amazon.com/dp/B0037X6NBM/?tag=atomicindus08-20

 

[NitroShark]

Im looking for a quality micro chuck that I can put in my M12 drill that will hold twist drill bits under 1/16". Ive seen several on the market but the quality of most looks dubious.

This is what you want. I use them for .03 Diameter and smaller micro drills all the time. (hand feed)





Albrecht Micro Drill Chuck Slip Chuck

.