Hi everyone,
I was wondering if anyone had a 204 with a split nut that they could send me some dimensions of so i could machine one for my newly acquired vise. Its 12TIP and i fugure the width of the oart is that of the channel on the main spindle, the large notches seem to be aribituary as they are to just get a punch in there for instillation and removal of the nut and the smaller grooves seem to have to just be big enough for the set screw to grab. However any dimensions or a better place to look for them would be much appreciated.
I was wondering if anyone had a 204 with a split nut that they could send me some dimensions of so i could machine one for my newly acquired vise. Its 12TIP and i fugure the width of the oart is that of the channel on the main spindle, the large notches seem to be aribituary as they are to just get a punch in there for instillation and removal of the nut and the smaller grooves seem to have to just be big enough for the set screw to grab. However any dimensions or a better place to look for them would be much appreciated.
