Spudland_Dave
Well-known member
Starting my light wiring project...currently have a 14-3 MWBC into a J-Box in the attic. Game plan was to/is to hook up lights in a yet un-determined format...note, lights aren't all installed yet, gonna onesie-twosie the install for time & $$ reasons. It would be nice to wire nut them all and call it done, BUT, for the time being I'd like to be able to add/remove/change the wiring config as I move along to fine tune what lights end up on what switch...ie for now they will all be on one, down the road I'll change as it goes.
Un-Doing/Re-Doing wire nuts isn't fun...those push-in deals are usually frowned upon...seem to recall some of those push-in connectors which had a little locking lever on them and them being "Better"..what are those called again?
Or any nice/elegant Terminal/Junction box solutions?
Un-Doing/Re-Doing wire nuts isn't fun...those push-in deals are usually frowned upon...seem to recall some of those push-in connectors which had a little locking lever on them and them being "Better"..what are those called again?
Or any nice/elegant Terminal/Junction box solutions?