Rolling axle Dolly

[Aggressive1]

Built this last weekend to be able to roll around a 2.5 to military Rockwell that weights about 700lbs. I figured I'd make my first post a minor contribution.

1/4" 1x1 angle, some 1/4" plate, 4 casters and some 5/16's bolts:

 

[Yotaforce]

That is pretty nice. I used to have some old pushmowers that I would strip off the motor and use the frame and handle to roll rearends around the shop with. That hole in the middle held them pretty well. I do realize your rear is much larger and heavier than mine for use with a pushmower body. Ha, that sounded wrong didn't it.

 

[kbs2244]

I like it.
You should go over to shopfloortalk.com and post it in their fabrication thread.
Those guys are doing this kind of stuff all the time.
I get lots of ideas.

 

[Aggressive1]

Cool, I'll check it out.