RotaryTech's Garage

[RotaryTech]

Hello.
Recently found this forum.
I like the idea of a garage forum. Brilliant!

Allow me to show off my garage.

The general work area. My shifty weld table setup in the foreground.

My original work bench. Made up from the cabinets that came with the house. And a 8x3?ft plywood panel.

My tool box.

My garage comfy chair.

Engines & Transmissions. (From back to front):
Triumph Spitfire engine & trans.
Ford auto trans from a thunderbird?
Mazda s4/s5(hybrid, lol) 6-port rotary engine.
Ford 5.0L 302 v8.
Mazda s4 6-port rotary engine.
Mock-up rotary engine w/s4 trans.
Another s4 trans (shifter showing).

And yes that is a cut-up bed sheet for a curtain/blind. lol.

 

[RotaryTech]

Also...

A 1983 Mazda Rx7 occupies one of the bays. Its in pieces. A lot of work to do on this one.

A 197? Triumph Spitfire 1500 occupies the other bay. Also in pieces. Lots of work to do on this one too. It sits on a homemade rotisserie.

Then above the garage is my Parts room. lol.

From the opposite direction.

The laundry room cabinets are full of these:

That's it for now.
Later.

 

[metalhead140]

Nice, you've got more engines laying around than me! Any more pictures? What cars are you working on?

 

[metalhead140]

Ahh, you posted before I did. Nice cars, and I'm loving the storage/parts room, I could use one of those... I have an MG Midget, Mazda 323 (GLC) with rotary conversion, and a '79 F250 with 351 Cleveland. I think we have similar tastes!

 

[RotaryTech]

So Saturday I was working on a welding cart, still needs some work.

I know, its made from wood, big & bulky, but it should do the job.

I'm going to make "guard rails" for the tanks, and something to wrap the cables around.

 

[MonoxieChild]

Nice! Always love seeing more Mazda guys! (})

 

[Dale Leeds]

Nice place. I think I could really kick back in that recliner and watch the race with a cold one, though.

 

[RotaryTech]

The cart is pretty much done.

There alot of room on this thing. I could slide the welders over & install some drawers or something.

 

[RotaryTech]

Update.

I've built a better welding table.
I think its still a work in progress, but this will do for now.
It can roll around my garage floor, It has a removable slats design, and panels to weld on. It has a panel or under-tray to catch sparks, and has storage space underneath.