Running lines

[anomm701]

I'm running electrical lines upstairs and I was curious if code allows me to run lines in between windows in the stud bays. There's two windows kinda side by side... If I can drop it between them I can run it right down to the box that's downstairs.
Is that acceptable per code? Thank you

 

[The Cobbler]

in my area that would be fine

 

[anomm701]

Thank you!

 

[justsam]

I assume there will be dry wall or similar to cover/protect Romex?

 

[mike93lx]

Make sure you secure it properly. Otherwise, send it

 

[anomm701]

I assume there will be dry wall or similar to cover/protect Romex?

Yes tongue and groove pine

 

[loganb]

From an electrical perspective the windows on each side don't matter. Follow the same requirements just like those windows weren't there and you're good.

 

[Zeke]

From an electrical perspective the windows on each side don't matter. Follow the same requirements just like those windows weren't there and you're good.

You're looking at the wrong wall.

 

[anomm701]

That's the correct wall

 

[Zeke]

That's the correct wall

You drew the line in the forward wall, not the exterior wall. At least that's the way it would appear to someone who has read plans for many years. And at that, it was a poor drawing going across the framing laying on the floor.

 

[anomm701]

You drew the line in the forward wall, not the exterior wall. At least that's the way it would appear to someone who has read plans for many years. And at that, it was a poor drawing going across the framing laying on the floor.

If you read what I said before looking at just the picture you'd understand the photo. Remember readers are leaders