Saw joints - color issues

[Dyers78]

I know this has been covered lots on here but I can’t find what I need. I just completed a gray stain/poly job in my garage. I’ll be posting more on that later. I need to fill my saw joints before winter slush season and was planning to use SikaFlex. Apparently they don’t make a dark gray and it sticks out like a sore thumb. I can’t find anything close to this dark floor to blend in. I don’t care if it’s a perfect match but there has to be a self leveling product out there in charcoal gray. If I use the Sika, my floor will look like a tic-tak-toe board. Can 100% silicon be used?? I know I’d have to tape and tool.

 

[Shea]

I know this has been covered lots on here but I can’t find what I need. I just completed a gray stain/poly job in my garage. I’ll be posting more on that later. I need to fill my saw joints before winter slush season and was planning to use SikaFlex. Apparently they don’t make a dark gray and it sticks out like a sore thumb. I can’t find anything close to this dark floor to blend in. I don’t care if it’s a perfect match but there has to be a self leveling product out there in charcoal gray. If I use the Sika, my floor will look like a tic-tak-toe board. Can 100% silicon be used?? I know I’d have to tape and tool.

Take a look at Metzger McGuire RS 88 joint fillers. They come in a variety of colors. https://metzgermcguire.com/products/polyureas-2/spal-pro-rs-88/

It's a polyurea filler and not a self-leveling polyurethane. With a little bit of taping and troweling it in I believe you can get the look you want.