Scored a Rotary Lift!!!

[Stouttrout]

I picked up a Rotary Lift this weekend. The only problem is it has no hardware. It is an SPOA7 model. Any idea where I should look for mounting bolt to mount it to the floor? I have a very thick slab for it to go on. Went to the hardware stores but they have nothing that large. Any idea of the size I need, lenght, type and Brand?

 

[Killer95Stang]

Call up Rotary and find out what size and type is needed.... then go to a site like www.mcmaster.com and order what you need.

 

[e-tek]

good work! post pics when its going up!

 

[SteveU]

Mohawk uses 3/4" X 5-1/2" WEJ-IT anchors for their 7000 lb lifts so I would think Rotary would use something similar. Congrats on the new lift.

 

[PAToyota]

I would definitely contact Rotary for their advice due to the potential for serious consequences resulting in the use of anything else. They can also likely provide you with operations, maintenance, and instruction manuals as well.

http://www.rotarylift.com/ask_us.aspx

 

[tfi racing]

Any good industrial supply will have what you need,Grainger,Fastenal,Hilti are a few that come to mind,not sure what you may have in your area.

 

[Rory Bellows]

TSC has large size grade 8 that you can buy by the pound. In my area it is around $3.68 lb. By far cheaper than most other places. It is a great idea to contact Rotary and ask for a hardware list. I would think it is included with every new lift to check if all the hardware is present.