screwdriver holder/organizer for drawer - magnetic?

[Sh40674]

wondering what you guys use for magnetic screwdriver holders for your tool chests? i was looking at some rails from ernst but they dont seem like they would do a good job keeping the screwdrivers from falling off if someone threw the drawer shut, so i started looking into magnetic screwdriver holders such as:

http://www.mechanicstimesavers.com/Screwdriver-Organizer-SDH15R-Red.html

http://www.lowes.com/pd_585352-12551-SDH15-RT_0__?productId=50265955

reading some reviews on amazon and such, some say the screwdrivers fall off.. now keep in mind i will NOT be mounting these on the wall, they are for in the drawer. Are they strong enough to hold the screwdrivers in place without tipping? what about larger screwdrivers?

i dont want to spend an arm and a leg, what are you guys using?

as for the rack itself sliding around in the drawer i have some super magnets i can glue to the bottom to make sure they stay put, thats not an issue

 

[Sh40674]

hard to imagine nobody here uses a magnetic screwdriver holder...

 

[hautpot]

Most people just throw them in there or use the trays included that comes with the drivers.

 

[Phantom552]

I used the tray that my drivers came in untill I got too many, now I just put them in the drawer, phillips heads and torx go tip-towards-back, flatheads and JIS go tip-towards-front, similar to how they are laid out in the magnetic rail photos... just minus the magnetic rail lol

 

[DemoFly]

I use this.

http://www.amazon.com/dp/B0002STRBI/?tag=atomicindus08-20

I ain't got time for opening and closing drawers. Not magnetic, but this would certainly fix your issue with drawer slamming.

 

[Sh40674]

even if i dont slam i get them rolling around all the time, drives me nuts

 

[gdocktor3]

HF sells a magnetic bar that's 18" If you wanna go cheap route. My solution to screwdrivers rolling around, buy more! Fill that drawer up! The pic below isn't recent. That drawer is stuffed. Every void has been filled. I also use a pry bar box for my extra long tips and short pry bars. http://m.harborfreight.com/18-in-magnetic-tool-holder-60433.html?utm_referrer=direct/not provided

 

[Sam'sAutoParts]

Most of mine are in Sunex screwdriver and pry bar that hangs on the side of my toolbox. The rest are jammed in the drawer so they don't move around.