To avoid these ads, REGISTER NOW!

Sears Battery Jump Box whistling

340wedge

Well-known member
Joined
Sep 8, 2012
Messages
391
I have a Sears battery jump box I bought in 2011, it still takes a full charge and works but whistles loudly while off. It sounds like when a fuse box has that high pitch whistle. The whistling is constant if it is low or fully charged. Is this dangerous? Junk it? Thanks:dunno:
 

Attachments

  • spin_prod_665399501.jpg
    spin_prod_665399501.jpg
    64.1 KB · Views: 1
To avoid these ads, REGISTER NOW!

CJCar

Well-known member
Joined
Feb 27, 2012
Messages
247
Location
South Central PA
I have a Sears battery jump box I bought in 2011, it still takes a full charge and works but whistles loudly while off. It sounds like when a fuse box has that high pitch whistle. The whistling is constant if it is low or fully charged. Is this dangerous? Junk it? Thanks:dunno:

I would say a capacitor is going bad - they start to leak or dry out and the top metal seal/lid of the cap will vibrate at high frequency.

You can find the bad cap by opening up the unit and putting pressure on the top of each cap, when the whistle is gone, you found the bad one.

Not dangerous in my opinion - eventually the cap will die completely though.
 
To avoid these ads, REGISTER NOW!

texvn

Member
Joined
Feb 26, 2015
Messages
13
Location
Southern California
I would say a capacitor is going bad - they start to leak or dry out and the top metal seal/lid of the cap will vibrate at high frequency.

You can find the bad cap by opening up the unit and putting pressure on the top of each cap, when the whistle is gone, you found the bad one.

Not dangerous in my opinion - eventually the cap will die completely though.

If it is a bad capacitor you should be able to identify it by a swollen, bulging lid on the bad component. But don't think that replacing the capacitor is the sole fix. Capacitors can fail due to age but they can also fail because of incorrect voltage being applied to them which could be caused by a number of components upstream in the circuit from the Cap. If you find a faulty cap use your multimeter to test the input voltage to it to determine if it is an aging cap or more.

I personally would fully discharge the box before working on any power electronics and as always be sure to wear eye protection as capacitors can explode.
 

Rookie2

Well-known member
Joined
Feb 27, 2013
Messages
1,925
Location
Western Pa.
only if it has an internal 120v charger, but it may be over charging the maintenance free sealed lead acid battery inside ! that's my guess !
 
To avoid these ads, REGISTER NOW!
Top Bottom