69f100
Well-known member
ive been looking at getting a welder lately because im tired of shee tmetal screws, and tape and all that stuff. and on top of that im finally starting to get a project truck going and theres afew spots that could use some help.
the only welder i have ever used is a mid range wire feed miller to weld up wrought iron panels and fill in afew holes in a trucks bed panel. now i figure i should get my own
fast forward afew weeks on craigslist
http://inlandempire.craigslist.org/tls/2818200749.html
i dont see much wrong with it and the seller doenst either. i already have gloves, helmet(s) and am on the hunt for full sleeves. so does this seem like a good welder for sheetmetal patches and medium sized tubing? thanks!
the only welder i have ever used is a mid range wire feed miller to weld up wrought iron panels and fill in afew holes in a trucks bed panel. now i figure i should get my own
fast forward afew weeks on craigslist
http://inlandempire.craigslist.org/tls/2818200749.html
i dont see much wrong with it and the seller doenst either. i already have gloves, helmet(s) and am on the hunt for full sleeves. so does this seem like a good welder for sheetmetal patches and medium sized tubing? thanks!