Show your motorcycle track tool box
- Thread starter solitaire
- Start date
fitz11
Well-known member
Here's mine
Bigblue&Goldie
Well-known member
^Nice box Fitz11^
Here's my track box. Beyond my dirt bike and quad (don't get to the track anymore
), I use it as a remote pit box for desert racing and four wheeling trips. I started with a Craftsman 250pc set as I wanted the blow molded case, and I need all 3 drive sizes and SAE/MM for what I work on. I still need to ad some swivels, a cheap multimeter, and other misc ****.
Gorilla Tape, Joe's tire gauge, ball pein, gloves, headlamp, pry bar, 18" breaker, allen keys, ignition wrenches, 1/4"-3/4" SAE & 7mm-19mm wrench set (wrapped in oiled shop towels), 10" adjustable, snap ring plier set, electrical crimpers/strippers, 5pc plier set.
3/8" socket set
1/2" socket set, Dzus button wrench, razor knife, finger bit driver
1/4" drive, sockets, bit driver and bits, torx sockets, 3/8" and 1/4" extensions, pick set, punch and chisels (wrapped in oiled shop towels).
Here's my track box. Beyond my dirt bike and quad (don't get to the track anymore
), I use it as a remote pit box for desert racing and four wheeling trips. I started with a Craftsman 250pc set as I wanted the blow molded case, and I need all 3 drive sizes and SAE/MM for what I work on. I still need to ad some swivels, a cheap multimeter, and other misc ****.
Gorilla Tape, Joe's tire gauge, ball pein, gloves, headlamp, pry bar, 18" breaker, allen keys, ignition wrenches, 1/4"-3/4" SAE & 7mm-19mm wrench set (wrapped in oiled shop towels), 10" adjustable, snap ring plier set, electrical crimpers/strippers, 5pc plier set.
3/8" socket set
1/2" socket set, Dzus button wrench, razor knife, finger bit driver
1/4" drive, sockets, bit driver and bits, torx sockets, 3/8" and 1/4" extensions, pick set, punch and chisels (wrapped in oiled shop towels).
Last edited:
I re-organized mine about the same time fitz11 did (sorry about the image size):
The tool roll in drawer #3 holds all my combination wrenches. The bottom drawer (#4 - not shown) is kind of a junk drawer - spare parts/bolts/fuses, grease, D-40, gloves, etc.
I left a little room to grow and put dividers in the top two drawers for bike-specific sockets so, that on a stable change I only have to re-cut smaller pieces of foam.
It weighs 46 pounds full (26 empty) so, adding side handles was pretty important to keep it manageable as a "portable" toolbox.
The tool roll in drawer #3 holds all my combination wrenches. The bottom drawer (#4 - not shown) is kind of a junk drawer - spare parts/bolts/fuses, grease, D-40, gloves, etc.
I left a little room to grow and put dividers in the top two drawers for bike-specific sockets so, that on a stable change I only have to re-cut smaller pieces of foam.
It weighs 46 pounds full (26 empty) so, adding side handles was pretty important to keep it manageable as a "portable" toolbox.
wkderf
Well-known member
Here's mine
love the shadowing on your drawers. Nice job!
logixjock
Well-known member
I love that Kennedy, what did it set you back?