Sk tool help requested

[foxx_good]

Hi i recently purchased a sk ratcheting screwdriver 73671 for dirt cheap ( identical to this one http://www.sjdiscounttools.com/skt73681.html) but it didnt with a bit adapter and i was wondering if any of you knew the size it takes and where i can get a quality one any help would be appreciated thanks

 

[foxx_good]

noone has an idea?

 

[old salvage]

It doesnt take 1/4" hex shank bits ?

 

[wilbilt]

The ratcheting S•K I recently bought uses a 1/4" male square shank with a 1/4" female hex on the opposite end. A bit odd, but it works.

 

[zuspiel]

The ratcheting S•K I recently bought uses a 1/4" male square shank with a 1/4" female hex on the opposite end. A bit odd, but it works.

Same here. But not really odd, though. It's the same arrangement as the Snap-On ratcheting drivers (except the tolerances for the shafts from SK vary a bit, one will fit the SO, the other one is a bit tight). Mind you, I only have a stubby SK, so YMMV...

BTW, more specific post titles help

 

[foxx_good]

Same here. But not really odd, though. It's the same arrangement as the Snap-On ratcheting drivers (except the tolerances for the shafts from SK vary a bit, one will fit the SO, the other one is a bit tight). Mind you, I only have a stubby SK, so YMMV...

BTW, more specific post titles help

Hey thanks for the help hopefully ebay will have some 1/4 adapters

 

[MAD]

That SK driver may not use the square drive shanks like the newer SK ratcheting screwdrivers. That one looks more like these:

http://www.amazon.com/Schroder-1-184-1-Pivoting-Ratcheting-Screwdriver/dp/B001DZ6YRE

http://www.sears.com/shc/s/p_10153_12605_00947473000P?vName=Tools

I am not sure what style those take.

 

[Frank Elson]

call in to a decent tool selling place and ask them ?
...er... take it with you.