Outlawmws
Well-known member
Things have been dead around here mostly for the past month, between weather (Rain) and holidays. Found these at one of our local monthly HS Fleamarkets.
A good old fashioned "Junk" dealer (first time I saw him) with lots of tools was there and most of it came from him. grand total: $4
4" Jorgansen, clamp USA made, an old Ford wrench, which is taking an Electrolysis bath today, and an OTC Ball/U-Joint Press, shown with the adapters I made for an old C-Clamp I setup for off road use in my rig. this will be much better with the fine thread, compared to the acme threads ordinary clamps generally have. I'll need to make up a stepped plate for the receiver, and the "punch" won't be needed any longer...
The pistol cleaning rod is actually a two piece, and came from a vendor I generally don't buy from as their prices are usually Eprey level + shipping... (or more) that one set be back a whole $2!
So $6 for all of it
A good old fashioned "Junk" dealer (first time I saw him) with lots of tools was there and most of it came from him. grand total: $4
4" Jorgansen, clamp USA made, an old Ford wrench, which is taking an Electrolysis bath today, and an OTC Ball/U-Joint Press, shown with the adapters I made for an old C-Clamp I setup for off road use in my rig. this will be much better with the fine thread, compared to the acme threads ordinary clamps generally have. I'll need to make up a stepped plate for the receiver, and the "punch" won't be needed any longer...
The pistol cleaning rod is actually a two piece, and came from a vendor I generally don't buy from as their prices are usually Eprey level + shipping... (or more) that one set be back a whole $2!
So $6 for all of it
Attachments
Last edited:
