Smoothing Rough Finished Concrete Floor

[dvcochran]

I have a shop area that is 672 sq/ft that has a very rough broom finish. The area has been converted to add an additional work area but the rough floor makes it hard to roll around on.

What is the best/easiest way to give the floor a slick finish? Once this is attained, should the concrete be sealed or coated?

Thank you for the advise.

 

[LegacyIndustrial]

Diamond grind the texture off and apply a polyurea coating system or our SECII SEALER will work, 2 coats, resembles polished concrete.
That texture will grind easy but will make dust so get a vac system to go with the grinder.

Good luck

 

[Armorpoxy]

Either a good grind, then coat, or use our www.suparatile.com industrial grade interlocking tiles. More expensive but a lot less work.

 

[nadogail]

Have the floor ground with a Diamond Grinder, you can have a flooring company do it as part of the prep for an epoxy floor.

 

[Garage Flooring]

Multiple successive grinds might be needed if you are not a coating. You could grind and do Poly or just cover with tile