Snap-on KRA 2" drawer height

[afazz]

I have a Snap-on KRSC326 cart and I would like to replace one of the 4" drawers with two 2" drawers. I know the 4" KRSC drawers are not the same height as the 4" drawers in my KRL at home, so I want to make sure everything will fit.

Can anybody with a KRA4107, KRA4813, KRA5311, KRA2007, modified KRSC46, or any other modern Snap-on KRA toolbox confirm that this stuff will fit in a 2" tall drawer? The tallest item is the Snap-on SHDX60O screwdriver set. Any 2" drawer pics would also be helpful.

 

[Ram Hemi]

Should be fine, I will measure tomorrow for exact height. I dislike the amount I 2" drawers I have, really limits what you can put in the drawers.

 

[413dan]

I have a kra4107, just went out and checked my box. I remember when putting in all new slides I could have put the 2 inch drawers below a 4 inch, but opted to leave them on the top(for the bottom box). what kind of drawer pics you want?

 

[afazz]

Thanks guys! Ideally I would like a picture of that exact screwdriver set in a KRA 2" tall drawer, but any pictures to give me an idea of what fits would help. The catalog says the drawers are only 1-5/8" tall, which is exactly the thickness of that screwdriver tray.

 

[thegroundpounder99]

They fit.





Sent from my iPhone using Tapatalk

 

[afazz]

Beautiful. Thank you!

 

[rebrewer]

Were you able to get two 2" drawers in there? What is the part numbers of the drawers if so?

Thanks!