Snap on Striking pry bars

[Hammell]

Well its time to track down the snap on guy again. Another broken handle on my 24 inch striking pry bar, seems they don't like the cold, they just blow up if you give them a couple taps. Anyone else deal with this? That's one 12in, two 18 in and this will be the second 24in. I guess that's what warranty is for? Youd think they would come up with something better but that said never had one break in above zero temperature.

 

[gtermini]

I haven't had an issue with handles breaking, but all except the little one in the set have had the handles pull off the shank while I was abusing them. I just mixed up some 5 min epoxy, poured it in the hole, then drove the shank back in.

Greyson

 

[bobcatdan]

I've broke a few tips here and there, but never a handle. Both of my sets started life as non striking and I never broke a handle on any of those beating on them.

 

[shockwave]

I have never had an issue with them before only the tips are a little thin compared to my Mathew/Matco versions I have been using for years without an issue

Any problems just call snap on I had the same issue and they sent me a new one right away