Snap on techangle buttons

[lotus_esprit]

I have a very recent Snap on Techangle ATECH2F125VB, all the light grey printing on buttons has rubbed off with very little use, has anyone else experienced this? I also have the earlier ATECH F100 (identical electronics and display, different head pivot) that has a lot more use, however the buttons on this wrench have white printing which appears to be far more durable and are still as crisp and clear as they were when new.

Neither have had solvent or any type of cleaner near them which could affect the button logos

 

[2ndGearRubber]

Mine have a few that are hard to read on my 3/8 and 1/2, and my 1/4 is mostly without any button markings left. I think the buttons on the 1/4 are more.... rubbery material than the other two which I think contributed to the loss.