Snap on toolbox side handle "new rubber"?

[90zcar]

There's a couple things on my box I am getting new of or refinishing slowly after I got my used krl a couple months ago.
I am going to get the ends of my handle powdercoated and I was trying to figure out a nice rubber replacement idea for the bar part. The handle is exactly 1" in diameter.

Any ideas?




Sent from my iPhone 5s using Tapatalk

 

[zkling]

Difficult->Piece of 1" ID hose.
Easy-> Nice grip tape, spiral wrap.
Rubberized coating?

 

[add2255]

1" heat shrink

 

[90zcar]

1" heat shrink

That won't crack over time?
Not a bad idea. Only other thing I was thinking is bike/motorcycle grips that come in the 2 foot "cut ur own length"


Sent from my iPhone 5s using Tapatalk

 

[90zcar]

Here's an idea I thought of. Would add a little "extreme green" color to my box aswell.
I would have to **** the two grips back to back



Sent from my iPhone 5s using Tapatalk

 

[wagzilla]

Here's an idea I thought of. Would add a little "extreme green" color to my box aswell.
I would have to **** the two grips back to back



Sent from my iPhone 5s using Tapatalk

nice!!

 

[90zcar]

I ended up using some road bike cork grip tape. Got a bad *** black/grey camo type pattern. Wasn't too bad to install it either. Can't wait to get the handle ends back from powdercoat now.


Sent from my iPhone 5s using Tapatalk

 

[90zcar]

Here she is. Powdercoated n re gripped



Sent from my iPhone 5s using Tapatalk