To avoid these ads, REGISTER NOW!

Snap On YA642 Floor Jack Help

J

jfake20

New member
Joined
Nov 20, 2010
Messages
3
Location
Myerstown, PA
Hello Everyone, I've been reading this forum for awhile now and this is my first post. I just picked up a snap on ya642 floor jack this week for $25 so I was pretty excited about that, anyway I flushed the hydraulic system and filled it with new hydraulic oil and now the jack will work fine with no load, as soon as I put a load on the jack it just bypasses ( I can hear it) and aerates the oil, so I guess its time for a rebuild. My problem is I don't know what series the jack is ie.. c d e. The sticker on the side of the jack is there but very difficult to read. So any help would be appreciated. The end of the jack to remove the ram takes a spanner wrench if that helps designate series. Thanks
 
To avoid these ads, REGISTER NOW!
To avoid these ads, REGISTER NOW!
OP
J

jfake20

New member
Joined
Nov 20, 2010
Messages
3
Location
Myerstown, PA
Thanks for the help guys, here's a picture of what I have. I think i'm just going to get a kit from Hiball, he seems like the way to go.
<a href="http://s1256.photobucket.com/albums/ii492/jfake20/?action=view&current=002.jpg" target="_blank"><img src="http://i1256.photobucket.com/albums/ii492/jfake20/002.jpg" border="0" alt="Photobucket"></a>
<a href="http://s1256.photobucket.com/albums/ii492/jfake20/?action=view&current=001.jpg" target="_blank"><img src="http://i1256.photobucket.com/albums/ii492/jfake20/001.jpg" border="0" alt="Photobucket"></a>
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom