Snap-On YA642 - saddle pad?

[elav]

Hello, I picked up a Snap-On YA642 floor jack that someone was giving away and just rebuilt it. It is now in working condition and will be a nice winter project striping it down and repainting it. It has a square saddle on it with the flat part of the saddle being roughly 5" x 5". I'm looking for a saddle pad that is either urethane or rubber and it would be nice if it has a slot in it for lifting cars with weld seams - my issue is that I can't find one to buy.

Does anyone know where I can get one? I've looked on eBay and Amazon and didn't turn up anything that is the right size.

 

[HotrodHR]

Buy a piece of rubber padding or stall pad from Tractor Supply or other supplier and make one. Cut to fit if it's not thick enough double the material glue with a good adhesive or contact cement... cut your own grove.

 

[zollster]

Stall mat from TSC will work great. Its good stuff. But.....I think it only comes in a 4' x 8' sheet.

 

[Stuart in MN]

Here's a 3" x 3" square pad with a slot for the pinch weld: https://www.ebay.com/i/222628096132 It may fit inside the flanged edge on your saddle.

 

[elav]

Thanks Stuart - ordered one. Would love to find one that is 5x5 but this is close.