snap ring size for CM 44811

[TinKnocker]

I have a craftsman raised panel 44811 3/8 ratchet that needs a retaining ring and a ball. whats the size of the ball, i have found 0.146" on the site, but where to get one? i also need a the ring, i found some at menards but they are too big.

 

[GirlnAgarage]

http://www.ebay.com/itm/ws/eBayISAP...3146&item=200704293146&lgeo=1&vectorid=229466

 

[TinKnocker]

i can fix this ratchet for pennies and a trip to the hardware store if i know the ring size. the two other ones were .55 and .75 cents (too big.) the ball is a 5/32

 

[GirlnAgarage]

Sorry was confused with the question "but where to get one?"

 

[TinKnocker]

im not mad

 

[GirlnAgarage]

Pulled the snap ring off my 44811 and it measured 15/16" in diameter.

As for the cost of an ebay kit, $8 is a wash for me. A gallon of diesel for the trip is $4, plus time, hassle, traffic, construction, heat, bad drivers, irritation, aggravation, going to the next store because the other doesn't have the one size I need - it's easier to order it online and have it come to my mailbox.

Anyway, hope that measurement helps.

 

[TinKnocker]

for the future:

the ball size is 5/32 (its actually bigger than the normal, but works MUCH better) .33 cents
the retaining ring size is 7/8 (part number 83122 handi-pack brand at menards) .75 cents