Snappy Master Series Drawer End Cabinet

[flyingtpot]

Anyone have a pic or description of the bottom design of a Snap-on Master Series drawer end cabinet such as the KRL1221, KRL1011, KRL1098, KRL7011 OR KRL711? I'm going to use one in an application that doesn't have it attached to a roll cab. Are there any threaded features in the base cavity?

Thanks

 

[flyingtpot]

Anyone? Any info?

 

[tjmonsen5]

I have a 711 but I'm in a hotel all week. I highly doubt there are threaded inserts in the bottom. They are designed to hang on the lip. You could make a little rollig chassis to set it in though.

 

[flyingtpot]

I have a 711 but I'm in a hotel all week. I highly doubt there are threaded inserts in the bottom. They are designed to hang on the lip. You could make a little rollig chassis to set it in though.

I too doubt there are threaded inserts on the bottom. Just want to verify that. Yes, a rolling chassis can easily be made or purchased. I basically just want to review all options as a decision hasn't been made on the final use of it. I'm getting a KRL711. My plan was to get an answer or pic quicker from the GJ than waiting for a Snappy CS reply. I'd still be interested in a pic or description when you get released from the hotel.

Thanks

 

[tjmonsen5]

What are your plans for the cabinet?

 

[flyingtpot]

What are your plans for the cabinet?

I'm leaning towards a custom rolling chassis and have it parked next to cylinder head machine. It will hold excess tooling, new guides, new valves and machine specific metrology equipment. I have a new one ordered from the Snapsters in a custom color.