I've got a used lot of stuff I picked up from work through an auction and had plans of doing something with but now just tired of it sitting on my work table. I went through and kinda sorted it by drive size and std vs deep. SAE is on the right side and metric on the left. 1/2 on top working down towards 1/4. The 1/4 on rail are all nice Proto Professionals and have metric and sae on them. There are a few repeats in there as well. About 3-4 3/8 drive short 1/2s for example. Brands include mostly Williams, Craftsman, some Proto, Armstrong. Some have markings as to certain places on the floor, some show some impact use, but not to bad, most are just marked with tape though. Nothing I wouldn't have a problem using though.
The two rails, one is a snap on and the other an armstrong, both 1/4"
Misc wrench's. Blackhawk shows some chrome loss on the open end.
Some of the better stuff. a 5/8s industrial 3/8dr SO socket, a very nice 3/4 3/8dr SO socket, 1/2 proto impact socket, 3/8s, and CMan 3/4, 3/8dr swivel (has an X scribed and light gouging on the universal sides)
drive end of the extensions. left to right is 2 Proto 6", 2 Williams 6" CMan 6", Proto Challange 6", CMan 10", 2 Snap On Industrial 11", Napa 1/2"dr 6". Oh, an a short SK. None of these have markings I saw, other than just some tape.
Also a 1/2"dr CMan speeder.
slight chrome loss on the end
I tried to describe it all the best I could and think I got it all. If there's any questions or want to see something closer let me know. Not looking to split it up. All this shipped out for $85 though obo.
Ok, so the blackhawk isn't USA, or the Crescents either I think. My bad.
The two rails, one is a snap on and the other an armstrong, both 1/4"
Misc wrench's. Blackhawk shows some chrome loss on the open end.
Some of the better stuff. a 5/8s industrial 3/8dr SO socket, a very nice 3/4 3/8dr SO socket, 1/2 proto impact socket, 3/8s, and CMan 3/4, 3/8dr swivel (has an X scribed and light gouging on the universal sides)
drive end of the extensions. left to right is 2 Proto 6", 2 Williams 6" CMan 6", Proto Challange 6", CMan 10", 2 Snap On Industrial 11", Napa 1/2"dr 6". Oh, an a short SK. None of these have markings I saw, other than just some tape.
Also a 1/2"dr CMan speeder.
slight chrome loss on the end
I tried to describe it all the best I could and think I got it all. If there's any questions or want to see something closer let me know. Not looking to split it up. All this shipped out for $85 though obo.
Ok, so the blackhawk isn't USA, or the Crescents either I think. My bad.
Last edited:
