Socket Trays?

[tomgriffin]

After just buying some 1/2" SAE shallow impact sockets (3/8 - 1") and I will be buying 1/2" shallow metrics soon (10mm - 24mm) I am after a decent socket tray/rail which can hold both sets together...

I am after something like this: http://www.concepttools.co.uk/Products/ViewProduct.aspx?ProductID=3280&RangeNo=24

But want the pegs to be the same height (preferrably long pegs) and be numbered 3/8 - 1 and 10 - 24

Any help appreciated
Tom

 

[tomgriffin]

LOL, 117 views and not one reply

Must be because i'm English

 

[alex71]

there are the hansen trays (which you linked to), and imitations of them, but none have the pegs all the same length. if you want that, you will have to build your own.

 

[daveblank]

If I'm reading your post right, you're looking for a single tray marked in metric & standard? If so, I've never seen them.

Or try these. They're not marked though.
http://www.matcotools.com/Catalog/toolcatalog.jsp?cattype=T&cat=2445&page=12&#64616

 

[tomgriffin]

there are the hansen trays (which you linked to), and imitations of them, but none have the pegs all the same length. if you want that, you will have to build your own.

I think I may just by some peg board and do that as I have searched the net and found nothing

If I'm reading your post right, you're looking for a single tray marked in metric & standard? If so, I've never seen them.

Thats correct Dave, its basically a two birth peg style holder which can hold both metric and imperial sizes on the same tray

 

[psychoclaw84]

Your request sound like a need for a custom order or build.

How about this set from Cal-Con, the Fast Rack II?

http://cal-conproducts.com/html/fast_rack.html

These are expensive, but I hope this might work out for you.

 

[Zrexxer]

How about this set from Cal-Con, the Fast Rack II?

http://cal-conproducts.com/html/fast_rack.html

These are expensive, but I hope this might work out for you.

I'm always a little amused at these trays or rails that have one or two sets of clips for a ratchet and an extension... so where am I supposed to put my other 23 ratchets?

 

[rcm296]

Why don't you just get one of each, metric and SAE (Hansen Trays), then you have room for expansion if you decide to get the matching deeps?

 

[Sloper0204]

Your request sound like a need for a custom order or build.

How about this set from Cal-Con, the Fast Rack II?

http://cal-conproducts.com/html/fast_rack.html

These are expensive, but I hope this might work out for you.

$100 for that? And it has huge holes right in the middle of both sides for their logo that could have been used for another 23 sockets? I could see doing the logo once, inbetween the 3/8 side and 1/4 side, but right in the middle of both?