jamesemery728
Well-known member
- Joined
- May 2, 2009
- Messages
- 961
Made a simple little, but useful project this morning from some scrap copper that I have had for quite some time. Will probably have to make 2 posts out of this to get all the pictures in.
1. Started with a paper pattern. If I can draw it I can usually make it.
2. Traced the pattern onto the copper and cut it out with some tin snips.
3. Bent over the straight edges to add some strength.
4. Edges bent over and flattened.
1. Started with a paper pattern. If I can draw it I can usually make it.
2. Traced the pattern onto the copper and cut it out with some tin snips.
3. Bent over the straight edges to add some strength.
4. Edges bent over and flattened.
