mattthemuppet
Well-known member
- Location
- San Antonio, TX
This is my Grizzly 6x26” metal milling machine. I’ve had it for six years and love it to bits, but a bigger mill is on its way and this needs a new home!
Features and mods:
- travels are 6x28(modded)x16”(with 4” riser block)
- 2hp DC variable speed motor (runs off 110V) with forward and reverse. Three different belt positions and the variable speed give ~150-3000+ rpm range.
- one shot oiler that was recently replumbed to include both nuts/screws as well as all sliding surfaces. Works very well and is easy to use
- quill digital read out with ~3-1/2” travel
- custom made stand with leveling feet and casters, which makes it easy to position and then get level
Tooling:
- 4” Kurt-style vise with work stop and spare soft jaws
- 51pc clamp set
- R8-ER25 collet chuck with ball bearing nut, inch 1/16-5/8” and metric 1-16mm collet sets and wrenches
- full set of R8 by 1/16” collets
- 1/2” Jacobs drill chuck
- Indicol quill indicator mount with 0.001” Ace and 0.01mm Mitutoyo dial test indicators
- 3” Yuasa boring head with indexable boring bars
- 2” 45deg indexable face mill
- set of parallels, v-blocks and 1-2-3” blocks
- selection of good used HSS and carbide endmills to get you started
- spare working power feed (was going to adapt it to the knee)
Pickup in north west San Antonio. Loading onto a drop deck trailer will be a piece of cake
Features and mods:
- travels are 6x28(modded)x16”(with 4” riser block)
- 2hp DC variable speed motor (runs off 110V) with forward and reverse. Three different belt positions and the variable speed give ~150-3000+ rpm range.
- one shot oiler that was recently replumbed to include both nuts/screws as well as all sliding surfaces. Works very well and is easy to use
- quill digital read out with ~3-1/2” travel
- custom made stand with leveling feet and casters, which makes it easy to position and then get level
Tooling:
- 4” Kurt-style vise with work stop and spare soft jaws
- 51pc clamp set
- R8-ER25 collet chuck with ball bearing nut, inch 1/16-5/8” and metric 1-16mm collet sets and wrenches
- full set of R8 by 1/16” collets
- 1/2” Jacobs drill chuck
- Indicol quill indicator mount with 0.001” Ace and 0.01mm Mitutoyo dial test indicators
- 3” Yuasa boring head with indexable boring bars
- 2” 45deg indexable face mill
- set of parallels, v-blocks and 1-2-3” blocks
- selection of good used HSS and carbide endmills to get you started
- spare working power feed (was going to adapt it to the knee)
Pickup in north west San Antonio. Loading onto a drop deck trailer will be a piece of cake
Last edited: