Solid Surface Edge Profile

[cadtech05]

I'm fabricating my first Corian countertop and I am trying to duplicate the edge profile on the attached Corian picture. I have searched for a router bit that matches the profile but with no success. I believe the edge is called cove or small ogee. Does anyone have a suggestion? Thanks.

 

[cvairwerks]

Looks more like a rabbit that has been radiused.

 

[rayh]

Send the picture with dimensions to Whiteside Rounter Bits salesmn and they can set you up. They're pretty good bits also.

 

[glentre]

Looks like a 1/16" cove bit followed by a 1/16" round over bit on the top edge. Check www.toolstoday.com

Glen

 

[ghnl]

Look for an ogee router bit.

 

[KenC]

Roman Ogee I think. Set to cut shallower than usual (no sharp edge at top) and with a larger pilot bearing to remove the edge at the bottom.