Source for "retainer" clips for jack axle, lift arm, etc.???

[200.447]

Where can I buy these in 1/2, 3/4 and 1 inch i.d. sizes?

Plan B would be to flatten them out and attempt to reuse.

Thanks-

 

[Galaxie-Ed]

Try fastenal or McMaster Carr?

Sent from my SM-J320V using Tapatalk

 

[APEowner]

I'm not sure what those looked like originally but McMaster-Carr is my go to for things like that.

 

[ttpete]

I'd go with Truarc snap rings.

 

[200.447]

I'm not sure what those looked like originally but McMaster-Carr is my go to for things like that.

They were totally round. Taking them off sprung them a little.
The 1/4" was bent up already and almost fell off.
I'll try McMaster-Carr. Thanks.

 

[200.447]

Fastenal and McMaster had nothing. (Plenty of snap rings though!!)

I'll make my own, starting off with close sized lock washers and worked them to fit.