You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Stainless steel top wanted
- Thread starter yellowbox
- Start date
Wiz02
Well-known member
Just go to a metal supplier and have them cut/bend one to size.
I did that many years ago. Dragged that 6ft bench top back home in the trunk of my '77 Cadillac Brougham winter beater no problem. What a land yacht that was!
Htscheg
Well-known member
Where are you located? I have a snap on one for a 54" box that I no longer use or need
Lookin4'67Galaxieconv
Well-known member
Snap On discontinued the KRL 722?!I have a KRL 722 SNAPON toolbox I want to put a stainless steel top on
Does anyone here know where I could get one made?
I could go thru snapon but the box is discontinued and it seems everything is on backorder
Big Bad Dad
Well-known member
Any sheet metal shop that makes commercial restaurant vent hoods could probably make you one.
29 inches wide x54 longWhat are your dimensions? There are a few off the shelf tops from the likes of Viper and Homak that might be a close enough fit.
My mistake my box is a krl7022Snap On discontinued the KRL 722?!
Lookin4'67Galaxieconv
Well-known member
Gotcha. I have a 722 with the stainless top. Looking for a red hutch myself.My mistake my box is a krl7022
Ouch. 29" will be tough. 22 and 24/25 are pretty common but I'm not aware of an off the shelf 29" top.29 inches wide x54 long