straight 6 point 3/8'' wrench?

[Hytekrednek]

I have been looking with no results for a 3/8'' six point wrench that is straight, no 15 degree offset. A long version would be even better but not required. Any finish is fine. Any suggestions? A combo wrench, or even a double box will work as long as there is no offset. Thanks for the help.

 

[bob15]

Snap On makes 0° offset box end wrenches, but they are 12 point.

Another option is to make your own. Find a 6 point wrench heat it and bend it to what you want (straighten it). You could also weld to it to make it longer.

 

[KnurledNut]

Does is have to be fixed or will a ratcheting wrench work? If so, check out SK X-frame.

 

[Hytekrednek]

I prefer fixed for the smaller head size

 

[ChevyEFI]

keep your eyes peeled for the right long-pattern, and un-bend it straight.

 

[gatlibs]

SK's new ratcheting wrenches are longer as mentioned above. Also, the older laminated, original, ratcheting wrenches can be found in straight versions. Offset wrenches aren't bent to be parallel to the handle at a distance from the handle. That may be helpful to your desires as well.

 

[theoldwizard1]

keep your eyes peeled for the right long-pattern, and un-bend it straight.

These are hen's teeth ! I have been looking for reasonably priced (used) long pattern DBE for months. The few I find are all 12 point and people must think they are made of unobtainium !

 

[theoldwizard1]

I have been looking with no results for a 3/8'' six point wrench that is straight, no 15 degree offset. A long version would be even better but not required.

This could be cut out of 3/8" or 1/2" flat bar on a water jet in about 5 minutes ! A bit of deburring, chamfer the edges and boom !

 

[scubadoober]

KTC has them.

 

[Hytekrednek]

KTC has them.

I have looked but cant find them. Do you have a link, or source? Thanks for the help

 

[Nero]

These are hen's teeth ! I have been looking for reasonably priced (used) long pattern DBE for months. The few I find are all 12 point and people must think they are made of unobtainium !

Can they be ratcheting? And what do you define as long pattern?

 

[KnurledNut]

KTC has them.

I have looked but cant find them. Do you have a link, or source? Thanks for the help

Only in metric.

https://www.nepros.net/?cat=3&grp=15

 

[Hytekrednek]

Only in metric.

https://www.nepros.net/?cat=3&grp=15

So close! Those are nice and would be perfect if available in 3/8''.

 

[chevy302dz]

How about something like this has a offset from the handle but the end is still linear to the handle.
https://www.ebay.com/itm/SNAP-ON-TO...047784?hash=item3659931e68:g:AMMAAOSwCB1d8VfM

 

[Hytekrednek]

that is better than the 15 degree offset wrenches, but I will hold out for a straight wrench for now. I did find a tekton ratcheting 3/8'' 6 point straight handle. If I cant find a non ratcheting version, I may give it a try.
Thanks for the help and ideas.

 

[toolaholic]

https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/173646600678 The 3/8 end looks to be 0 offset