T/G Router bits 5/32

[Certified Drunk]

Anyone know where I can get a T/G router bit for some 7/16" think cedar. The tongue is about 5/32.
Custom Router bits are $$$

I'm going to install new soffit's on the house and want to end finish the boards.
Thanks

 

[MFolks]

Try www.rockler.com or www.woodcraft.com

 

[Zeke]

You would do well with a dado blade and a slot cutter both of which can be used on future work as opposed to a dedicated bit set. Actually you don't NEED the dado as you could use the slot cutter or circular saw to cut the cheek. Or you can spline them using only one setup using the slot cutter.

 

[ryan20021982]

If you only need the groove your best option for that size tongue would be just a slot cutting bit and run the boards through the router table.

Here is a 3/16" slot cutter which is only a 1/32" larger so would give you a little play if needed
https://www.amazon.com/dp/B0002TUD2O/?tag=atomicindus08-20

 

[Zeke]

If you only need the groove your best option for that size tongue would be just a slot cutting bit and run the boards through the router table.

Here is a 3/16" slot cutter which is only a 1/32" larger so would give you a little play if needed
https://www.amazon.com/dp/B0002TUD2O/?tag=atomicindus08-20

You're gonna stand the boards on end on the router table? Tell me you're not a woodworker.