Table saw cabinet design?

[bcoke]

I just got a powermatic 66 table saw and need design ideas for a "cabinet" to hold it with extension tables fixed and folding with some tool storage included. One picture is worth a thousand words.....thanks bcoke

 

[Randy in Maine]

Nice saw.

This guy has a pretty nice set up...

http://www.ebay.com/itm/Powermatic-66-Tbl-SAW-WOODWORKING-10-5HP-Tilt-Blade-/400550936057

I am still building this set up for my Rockwell contrctors saw.....

http://www.shopnotes.com/plans/table-saw-workcenter/

 

[ddawg16]

That project is on my list as well.....I've got the Ryobi table saw...here is a pick of what one guy did.....

But in my case, I want to do something a bit bigger. I do a lot of woodworking...so I want a combination table saw/wood working table. Since I don't have a lot of space I want to make something that I can wheel out into the middle..use it then wheel it back to the corner....

I need an outfeed table...but that also makes a good work surface....so I plan to make it dual use.

For me, I'm thinking about 5' wide and about 4-5' deep....with the table saw on one side...and lots of drawers below...

I'm even thinking of embedding a small shop vac to collect the saw dust....

 

[pattenp]

This is not a cabinet but another idea for you table saw.

http://www.thewoodwhisperer.com/videos/tablesaw-outfeed-table/

 

[Nestor]

I'm planning something similar.

I'm inspired by this design. It incorporates the router table and outfeed table as well.

Plus, he's using the same saw I have.

 

[BigSteve63]

I'm planning something similar.

I'm inspired by this design. It incorporates the router table and outfeed table as well.

Plus, he's using the same saw I have.

Shop Notes magazine had plans that were similar to this one. I have a pdf of the plans with cut list, but don't think it would post up here.

 

[Zeke]

This is not a cabinet but another idea for you table saw.

http://www.thewoodwhisperer.com/videos/tablesaw-outfeed-table/

Jeez, a 30 second commercial to see a ******* bench.

 

[PCO6]

^^^ No commercial here but I've had that happen many times and it's ****** annoying. Sometimes I've clicked on something and got a 30 sec. commercial. I checked the same link later and get a 15 sec. commercal or none at all. There's no rhyme or reason

 

[driver]

Nice saw.

I am still building this set up for my Rockwell contrctors saw.....

http://www.shopnotes.com/plans/table-saw-workcenter/

I have built this one also. It extends the work surface immensely and makes sawing larger pieces much safer.

 

[Randy in Maine]

I have built this one also. It extends the work surface immensely and makes sawing larger pieces much safer.

I am working to tweak it a little to fit my 52" unifence and make it so it will roll under my chop saw station.