Old tool guy
Well-known member
- Joined
- Apr 13, 2023
- Messages
- 3,434
So my first tpu print came out well, no problems printing after i got started. However … removing the support trees was a real ******, they were stuck pretty good.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
The Everything 3D Printer Thread
- Thread starter BoilermakerFan
- Start date
mike93lx
ALLIANCE MEMBER
Layer adhesion on tpu is amazing.So my first tpu print came out well, no problems printing after i got started. However … removing the support trees was a real ******, they were stuck pretty good.
I have had good success with 3 top interface layers and rectilinear for the pattern
Old tool guy
Well-known member
- Joined
- Apr 13, 2023
- Messages
- 3,434
I normally use pla for the interface with petg prints and it comes apart cleanly. Not an option here. I will try those settings.
Old tool guy
Well-known member
- Joined
- Apr 13, 2023
- Messages
- 3,434
Did only one part break? Can you show a picture of the unbroken piece?Thanks for the info LOGANB.