The Standard Electrical Tool Co.

[ssffnomad]

Buffer/Polisher. 36" spread on Buffing Pads.
Model # 100, 3/4 HP.
On each side of Motor , it has a Pipe Plug on bottom of Shaft, and two on Top. Do I Oil the Top Plugs ? Pulled Bottom Plugs - Dry.

 

[ssffnomad]

Ya i know, i am replying to my own post
Found this info : http://www.owwm.org/viewtopic.php?f=77&t=131348
They discuss changing to Sealed Bearings. Comment about Plugs and Grease Fittings both used. If it now has Plugs and is Bone Dry, would you Oil, or install Grease fitting ? Just got it, and it runs quiet.
Thank You

 

[garthg]

Where did you find that machine?

 

[ssffnomad]

My Buddy had it. Came out of a School Shop years ago.

 

[ssffnomad]

Finally got around to posting a Pic

 

[Outlawmws]

What did you pay? 'Cause I think you may ****...

 

[ssffnomad]

Well actually my friend *****. He got two of the same Buffers. Does alot of Stainless Auto Trim Polishing. He wants to keep both, as to have 4 different compound wheels. So he lent my one to do my Nomad Stainless. Even offered to do finish Buff on it after i get it close.