This is a Killer Tool

[dnschmidt]

I've been looking for a bit holder to hold 1/4" power bits for use with my 3/8" drive ratchets and impacts. This baby is the absolute bomb. It has an adjustment screw at the bottom the enables you to completely remove the slop typically associated with bit holders. SUPER HIGHLY RECOMMENDED!!! https://www.amazon.com/gp/product/B08JQ7LK8C/?tag=atomicindus08-20

 

[mike93lx]

That looks nice. I've been using a tekton 1/2 drive bit holder, which get very hot when I run 8" structural screws on my 1/2 high torque impact. I wonder if if this would be any better.