I would like to see a few tips on making the job easier "Thread"
For example when using a Hole saw Instead of using a expensive lube when you run out in the middle of a job use good old cooking Lard you get at any grocery store. We used this when cutting holes in Stainless Pipe and Sheet Metal, Tubing etc. When packing the hole saw body full it slowly melts and keeps the tool cool.
Short cuts that really work etc.. I think it would help the new comers a lot in learning easy ways to do the job right and quickly.
I hope I am posting in the right place here.
For example when using a Hole saw Instead of using a expensive lube when you run out in the middle of a job use good old cooking Lard you get at any grocery store. We used this when cutting holes in Stainless Pipe and Sheet Metal, Tubing etc. When packing the hole saw body full it slowly melts and keeps the tool cool.
Short cuts that really work etc.. I think it would help the new comers a lot in learning easy ways to do the job right and quickly.
I hope I am posting in the right place here.