Tilt base for mid size router

[propmaker]

This is a tilt base I made over the weekend. Its for a specific job I have, I will set it up with a trammel arm to swing a radius on an angle. This is version 1.0 I'm sure improvements will come. I need to start looking for a better drill press, mine has too much run out.

 

[propmaker]

Eventually I'll cut a slot in it and add the aluminum angle to it. I make them this way so I could make it any length I want by adding a 1x3.

 

[Kscardsfan]

That’s really slick. I want one for myself lol.

 

[The Cobbler]

cool project. not sure if I need 1, but I want one ! LOL