TL37 and Ghost Shield 8510 install advice plz

[swharris]

Well, most all of the construction is finished on the garage/apartment. I've got a free weekend so am finally planning on laying down the TL37 and Ghost Shield. So far the guys have kept the slab very clean except for some small drops of resin that the framing has dripped, but those spots should come up easily.

The slab is virgin so does not really need any "cleaning" except a good vacuuming(I have a large exterior walk behind vac). Should I bother with light pressure washing or is that just a waste of time?

My main question is how much time should I wait between the application of the two products? The data sheet says wait 24 hrs before walking on it.

Thanks for any comments.

This is the place. The approach is dry now. All the junk is out.
https://goo.gl/photos/xfyPKdekXdHPswyt6

 

[jkeyser14]

7 days according to ghostshield's instructions if you had used their densifier.

 

[Shea]

Yep, wait seven days to apply the 8510 after you have applied the densifier. The reason is densifiers are a reactionary sealer and it takes that long for them to fully do their work.

 

[swharris]

Thanks. I finished a single coat last evening. I think I underestimated the amount. I was told for the square footage, 3 gallons (diluted 50/50) would be enough. After doing the entire floor one full coat, I've only got about a gallon of mix left. Should I get more to finish a second coat or will the one coat be enough??

 

[Shea]

One application is enough. Particularly since your floor looks smooth. Adding a second application would most likely require scrubbing it in.

 

[swharris]

One application is enough. Particularly since your floor looks smooth. Adding a second application would most likely require scrubbing it in.

Great! Thanks for the reply.

 

[Garage Flooring]

One application of densifier is more than enough. For 8505/8510 you want two applications, wet on wet. For stand alone densifier applications, their are times we suggest two coats.

 

[swharris]

One application of densifier is more than enough. For 8505/8510 you want two applications, wet on wet. For stand alone densifier applications, their are times we suggest two coats.

Thanks. 8510 will go down this weekend hopefully.