itsajeepthing
Member
Recent GJ member....got on here to seek advice and get some ideas during my project. I started with a cookie-cutter 2 car attached, with a terribly low ceiling height, especially for a pair of Jeeps. It started with demo'ing all the drywall, running new electrical where I needed it, insulating the bejesus out of it, running a gas line for a future heater, then replacing the trusses with the most aggressive scissor trusses I could get by code. Oh, and a vented skylight for good measure.
Lower 3' of the walls are cementboard, covered with galvanized, and the uppers are OSB covered with stained cedar fence pickets. The ceiling is getting a single run of galvanized along the eaves, with cedar to the peak.
Lower 3' of the walls are cementboard, covered with galvanized, and the uppers are OSB covered with stained cedar fence pickets. The ceiling is getting a single run of galvanized along the eaves, with cedar to the peak.
Attachments
-
58461623_10212640162990684_4078532413506977792_o.jpg113 KB · Views: 367 -
58606464_10212640161190639_2366732846468431872_n.jpg83.5 KB · Views: 383 -
58384572_10212640167670801_2025196733557899264_o.jpg157.8 KB · Views: 406 -
58543635_10212640166750778_2406275291807744000_o.jpg151.1 KB · Views: 397 -
58656804_10212640164630725_8080495825098113024_n.jpg104.1 KB · Views: 366
