Toolbox pull knob modification....

[holt2ton]

Soooo...I did a little bit of modification to my tool box....sure beats the plain black plastic drawer pulls...and yup I made them....

 

[MrJason]

I know a Snap On guy, in Los Angeles- who tricked out his entire den with Cabinet Handles that were actual wrenches.

Jason

 

[Squashfest81]

Who doesn't love legos. Nice! Please share the process.

 

[holt2ton]

-I took one of the original knobs off and measured it up.
-Then I cut all of them from the backside all the way past the largest rectangular area.. drilled and tapped at that time also.
-Made a small holding block for the now done side to go into.
-Cut to final height and cut circles and text.
-Filled text in with paint.. let it dry
-A few passes on emory cloth on a flat surface and the text shows up..
-Take pic and post on GJ!!