Trim for full flake Nohr-S Polyurea.

[arcticjp]

What are you all using for floor trim on your full flake installs?

I have drywall in some spots, concrete, and some exposed foam that I would like to "trim out" and apply the coating to as well, for a seamless clean look.

Is Legacy Nohr-S still the best choice for a DIY friendly full flake install?

 

[benwah]

What are you all using for floor trim on your full flake installs?

I have drywall in some spots, concrete, and some exposed foam that I would like to "trim out" and apply the coating to as well, for a seamless clean look.

Is Legacy Nohr-S still the best choice for a DIY friendly full flake install?

You could check out my Speed Cove post and see if you like that look. Additionally, see if you want to put the time, money, and effort into it.

There is always vinyl cove base, not as appealing, but much more cost friendly and easy to apply. Cannot flake over it

Another option would be install wood trim, and flake over it...

 

[tncatadjuster]

have used masonite with good luck.

 

[Armorpoxy]

Agree, Speed Cove is a great product but $$ so vinyl inexpensive cove could be a great solution as noted above. We would suggest not coating over foam since the coatings could react with it and make quite a mess.