pascal32
Member
Hi there - anyone have suggestions on the spacing and layout for a Triumph C7000 lift? through the deciding phase and concrete check. This is a symmetrical lift with independent posts. Arms are triple telescopic 24"-53". I have a drawing in fusion 360 - unsure of the pivot pin spacing, should be close through.
24x48 barn - sliding door to one side. trying to keep enough space that I can pull a car in at an angle and use wheel dollies to put it on the side of the lift.
guidelines I've seen: 12' forward, 12' back, posts 2' from wall. There are numbers on the forum for width - unclear of the points used for the measurement (pin to pin, inside post or outside post).
I have the ALI lifting guide on order, unsure of when that will arrive.
Working on a variety of vehicles -
small SUV: 72" width without mirrors, 65" with on pinch welds
2015 dodge ram - 82" width without mirrors, narrow frame - 39" on center
family car: coupe 71" body width, pickup spot should be similar to small SUV but further apart
Thanks for the help!
Pascal
24x48 barn - sliding door to one side. trying to keep enough space that I can pull a car in at an angle and use wheel dollies to put it on the side of the lift.
guidelines I've seen: 12' forward, 12' back, posts 2' from wall. There are numbers on the forum for width - unclear of the points used for the measurement (pin to pin, inside post or outside post).
I have the ALI lifting guide on order, unsure of when that will arrive.
Working on a variety of vehicles -
small SUV: 72" width without mirrors, 65" with on pinch welds
2015 dodge ram - 82" width without mirrors, narrow frame - 39" on center
family car: coupe 71" body width, pickup spot should be similar to small SUV but further apart
Thanks for the help!
Pascal