I have an old #2 bender also. I built a hydraulic setup to work with mime so it sit's on a pedistal. Do you have 1-3/4 and 1-5/8 dies for bending tubing for roll cage? if you're not using them I'd buy 'em from you. I'm in Eastern, NC. I have the dies for bending angle iron about every way you can and a few other dies I'm not using.
I have a JD-4 electric/hydraulic which looks a lot like the RDB. When I researched Baliegh vs. JD, I found the dies to be less expensive for the JD-4. If you work on a lot of differnt size tubes, the cost of dies can eclipse the cost of the machine.
