Twin light face shield

[seber]

I picked up this Delta Rockwell with the Baldor and it has Twinlight faceshields but no bulbs. I looked for bulbs and found they cost $21 each times four. That's almost as much as I paid for the grinder with cast iron pedestal. Has anyone figured out a better way to light these shields. I know it can be done with an LED kit but those are $100 each.

 

[RTM]

What is the bulb number?

 

[Fluxion]

I have two Delta/Rockwell triple duty grinders with those face shields. Mine take a BA15d bulb, I used these from Amazon.

https://www.amazon.com/gp/product/B076LNG38Q/?tag=atomicindus08-20

 

[RTM]

Ba15d seems to be the base. Assuming 110v, what wattage?

Love the LED though, I am swapping many things to LED.

 

[Fluxion]

I am pretty sure the originals were 25 watt.

 

[RTM]

Here is a 25w for $5. What was special costing $21? Odd shape or size?

https://www.bulbtown.com/03750_25T8_DC_MODELING_LAMP_25W_120V_ANSI_BA15D_p/03750.htm

 

[seber]

That's the info I needed. Thanks guys. I didn't know what base designation was needed and the shield specific parts did not list it. This one runs on 208 three phase with an inverter but I'm sure the filament bulbs can handle that. LEDs are a good choice but more than I want to spend on my number three grinder. I only use it with a flap wheel and deburring wheel.
Edit.
Wow, did a little searching and found these. https://www.amazon.com/dp/B01KM7MZBM/?tag=atomicindus08-20
Even cheaper than filament bulbs and daylight white.

 

[RTM]

Nice. Any LED is usually better than halogen IMO.

#3 grinder..... I use the over head light on my only grinder.