Used Unisaw

[DavidR8]

That has nothing to do with the Unifence, only the side table and associated hardware which would be part of the saw rather than the fence system. The three primary components of the Unifence are the front horizontal rail, the locking fence carrier and the fence rail. Except for minor hardware, everything else is a component of the saw itself.

Agreed though the Unifence kit came with two lengths of angle iron to support the long sides of the extension table. On the rail side the angle iron bolts to the fence rail.


Sent from my iPhone using Garage Journal

 

[rlitman]

I do know the size. a24 or 4L260


Sent from my iPhone using Garage Journal

Gotcha. I’d use an AX24 then.

 

[rlitman]

Do you have photos of your design?


Sent from my iPhone using Garage Journal

I do now.

https://www.garagejournal.com/forum/showthread.php?p=8123157#post8123157

 

[DavidR8]

I do now.



https://www.garagejournal.com/forum/showthread.php?p=8123157#post8123157

Thanks!


Sent from my iPhone using Garage Journal

 

[DavidR8]

From the date cast into the eggshell motor cover I think my saw was made in 1965. For certain the cover was cast on Jan 5 or May 1 1965.



Sent from my iPhone using Garage Journal