Vintage roll cab handle end cap option

[Aeromech]

Guys,
I just bought a KRA-398A Aviation roll cab (Taco Cart). It's missing the rubber handle end caps. The handle part number is KR-402A.



I'm trying to either locate a set of rubber end caps or come up with a good alternate. Anybody got any ideas? TIA



This is what I need

 

[Aeromech]

Also,
Can someone please post the snap on red paint code? I'm going to use three part automotive paint from Sherwin-Williams but I need to know what to ask for. Thanks

 

[Lx460]

Those are long discontinued unfortunately. I'm sure you can probably find a set if you look hard enough though.

 

[zkling]

SOL unfortunately. That's not the true taco box, those are KR562.

 

[Aeromech]

SOL unfortunately. That's not the true taco box, those are KR562.

You mean like this?

 

[likes68Cs]

Can anyone give me dimensions of the rubber ends on the handle for the KRA-396 tool cart (taco wagon)? From my handle I estimate the inside hole is 5/8" x 1-5/8". But I don't know the outside dimensions, how thick it is and I know it has a taper from the handle side outward.
I also have confirmed they are no longer available from Snap-On. It goes on the KR-402A handle and is part number 396K5201. I would like to find a pair for myself and a pair for a friend. Short of that I would like to get an old one to use to make a mold and make some.
Thanks

 

[likes68Cs]

I have obtained dimensions of the wedge-shaped end cap on the handle. It is NOT the same as the nicely-molded end cap Aeromech showed above. If I tried to get some made, how many of you would be interested in a pair? I am thinking of having them machined from solid rubber. I think I would have too much if I had them made of silicone or urethane rubber. I have NO idea of the cost yet.

 

[930dreamer]

I'll look at my surplus Snap On handles and see if I can come up with a set.

 

[KRA-398 Newbie]

I'm looking for a single end cap if there is one out there?
Thanks
Robert

 

[KRA-398 Newbie]

See photos

 

[CGarage]

I need these as well. Someone should 3D print replacements.

 

[daddiosjg]

Has anyone made some of these?

 

[daddiosjg]

Turns out these fit pretty good

https://www.amazon.com/dp/B08KVVPS5D?tag=atomicindus08-20

 

[Wamsutta]

Also,
Can someone please post the snap on red paint code? I'm going to use three part automotive paint from Sherwin-Williams but I need to know what to ask for. Thanks

PPG Ditzler 73504