warped workbench framing

[Locker537]

I've started to build a simple workbench to put in my 8x16 shed. This is a general purpose bench with a simple plywood top and shelf.

I'm using the attached simple design as inspiration. I'm using leftover lumber from the shed build. The lumber has a few good bows in it. Currently the framing for the top has probably a 2-3 inch curve on one side.

Would you replace the offending stud, try to address the issue with some moisture and pressure, or simply ignore it?

I can snap a picture later today or tomorrow, but for now no picture.

 

[dogdog]

can you form it back ? as long as it is not dropping downward or upward... I did somehting like that on all 2 side of my garage.... using pressure treated and double 3/4 as top finished off with those leftover urethane for the flooring.

 

[jimgood]

I would not use a bowed plank for the frame top. Cut it up and use it for cross pieces or something.

 

[Locker537]

can you form it back ? as long as it is not dropping downward or upward... I did somehting like that on all 2 side of my garage.... using pressure treated and double 3/4 as top finished off with those leftover urethane for the flooring.

It's bending upward/downward. I wouldn't have worried otherwise.

I know I could simply replace the offending lumber, but I like to use these scenarios are a learning opportunity.

 

[Cyberbear]

Working warped wood isn't worth the effort. Replace it with a straight piece and be done with it.

 

[Locker537]

Fair enough, I'll swap out the offending 2x4.