Weaver Auto Lift?

[jdsac]

These guys are great- if it isn't a standard seal they can make one-

https://epm.com/products/standard-custom-hydraulic-seals

https://projects.iq.harvard.edu/files/epm_oring_handbook.pdf

 

[DYNO-DAVE]

Weaver is still making hoist, I just bought one about 2 years ago and love it. its a 10,000 lb. lift. What like about this model is its 10 inches wider than most and 10 inches taller. I'm fat and tall so need both features. I was not going to climb thru windows or bend over (swat down ) under the hoist. And it was the best price around. The most bang for the buck. Its very well built and everyone that see it really likes it.

 

[bwjpc92]

Anybody have dimensions on the overall width of an AFH-70 lift? And anyone that has one that's had any major issues since installing? I'm looking at one and debating getting it over an open center mid rise scissor lift since I have low ceilings (8'). Guy already said one cylinder leaks a tiny bit so I know I'd need to rebuild those for sure before use. Anyone have a manual with the installation specs, maintenance procedures, etc?

 

[kingranch007]

I understand that you have the manuals in "PDF" format for my lift. I would appreciate any assistance on these if possible. I have a AFH-72 Weaver. Thanks so much.

 

[BGutt]

The weavers are a self bleeding system. I fully raised and lowered mine a couple times.

Look here for the Weaver seal kits:
http://www.parts4lifts.com/store/page26.html

I also have a weaver cylinder identification document. Also have an installation/owners manual for AFH72 & AWH72 in pdf.

Could you send me the installation/owners manual for the AFH72 Weaver? I have an AFH72OH. I believe everything is the same on it except it is an overhead lift - chain goes overhead instead of under floor plate. Thanks! My email address is [email protected]

 

[ratflinger]

Could you send me the installation/owners manual for the AFH72 Weaver? I have an AFH72OH. I believe everything is the same on it except it is an overhead lift - chain goes overhead instead of under floor plate. Thanks! My email address is [email protected]

That post is 8 years old and the poster hasn't been seen since 2020 - do not expect an answer.